SLS NUB MOD® for Level 3 Holsters
Nub Mod for Level 3 ALS/SLS holsters. Also works on ALS only holsters. Click here to go to product-
-Angled to provide your SLS hood clearance over the Nub. -Grooved to minimize the chance of you thumb sliding off. -Hard anodized for a tough long lasting finish. -Comes with a washer and extra allen wrench for your holster screws. See Install instructions below.
SLS Nub Mod Install Video
1. Press the large portion of the Nub onto the factory button from the outside of the holster.
2. Align the notch and key and press the smaller piece into the notch.
3. Insert screw and tighten with small allen wrench. Loc-tite is recommended after initial fitting.
4. After bolting on the Nub Mod.
A: Using the large allen wrench, remove the belt loop screws. You may just loosen the lower screw and swing the loop out of the way.
B. Using the large allen wrench, remove the two top screws that secure the SLS mechanism to the holster. Be sure not to misplace the screws with the others.
C: Place the washer over the top threaded hole.
D: Reverse the instructions, and check for clearance of the Nub Mod. Notice the gap in the picture below.
Depending on your holster you may have to find a thicker washer. The 7TS holsters seem to run a bit tight on the hood without a Nub Mod due to the molding process. The non-light bearing 7TS holsters are very tight. In the picture to the right you'll see where I ground off a slight amount of material to make a smoother hood operation (red arrow).
NOTE: Some levers are a bit different than others due to molding, use, etc. One may simply remove a few thousands of plastic from the lower edge of the standard ALS lever as indicated by steel punch in image.
