OTD Deluxe Firearm Stippling Kit

  • Sale
  • Regular price $114.99

 100% Made in the USA!  From the molded case to the tips to the wire brush, this kit is completely made in the USA and all tips are specifically designed for firearms, not wood.  


25 Watt Woodburner with a short shaft for ease of control and a moderate temperature. 

Tan Hard Case for convenient storage of all your stippling items. 

One 20LPI Waffle Tip.

One 20LPI Square Tip.

One 20LPI Finish Tip.

One Point Tip.

One 16LPI Waffle Tip.

One 12LPI Waffle Tip.

One Diamond Tip

One X Tip

One Wagon Wheel Tip

One Chisel Tip

One Small Round Tip

One Large Round Tip

One Rectangle Tip

Two Large plastic vial to hold the tips.  

Three small plastic vials for the 20LPI tips and Finish Tip.

One piece of practice material, 2x6' and 1/8" thick so you can stipple both sides.

One wire brush for keeping your tips clean.  

 Grap a Tip Box that fits right into this case for extra easy storage if you need it. 

This kit does not include all OTD tips since the lineup changes often.

Legal Disclaimer:

This Stippling Kit must be used by a qualified gunsmith. If used incorrectly, injury, death, or property damage could occur. If not used correctly by a qualified gunsmith, Oregon Trail Defense LLC makes NO WARRANTY, EXPRESS OR IMPLIED regarding this kit. If not used by a qualified gunsmith the user releases and agrees to indemnify Oregon Trial Defense LLC from any claim of damages resulting from a malfunction, warranty violation, or property damage, and waives any claim for liability against Oregon Trail Defense LLC.


Common sense - take your time, practice on some old A2 grips, magazine floor plates, old clinton era 10 round Glock 17 mags (unless you live in a state that requires you keep them), some of the Practice Material we sell here etc.   This will give you familiarity with the tool/tips, and enable you to recognize some important things (outlined below).  Then  and only then should you move on to your firearm.  If in doubt, take it to an experienced gunsmith. 


 Time, heat, and pressure.  This is what controls the process.  

 Time: More or less time is required for some materials then others.  


 Heat: More heat is more suitable for some materials then others.  I recommend a 25watt woodburner for most users and most jobs. The burn just under 1000*F generally.  A 40 watt unit would burn so much faster that it would require less time and pressure.  Why not use a 40 watt then? Because it also makes it easier to mess things up. The tips are designed to increase productivity by covering more surface area rather then using and ultra hot tool. 


Pressure: Pressure controls the flow of material as you melt it. Realize that is what you are doing, melting the gun's material, allowing it to take the shape of the tip you are using.  Keep in mind different gun frames will 'melt' differently.  Glocks are harder material then XD's, M&P's removable backstraps are super soft and require a gentle touch.  Don't practice on a Pmag (one of the hardest things on the market) and then jump into your Glock and expect the same results while utilizing the same time/pressure. 


Some important notes: 

 You are not to be sinking these tips in very deep.  About 0.040" (thickness of 3 normal business cards) is generally the deepest you would go. Most time quite a bit less then that. 

Most colored gun frames will not retain the factory color, as the waffle tips will leave a small amount of material on the tip, resulting in your frame having a black tint to it in spots.  You can mitigate this by keeping the tip VERY clean with a brass/copper wire brush, but do not expect it to come out the same FDE tan, green or gray that you started with.